#
# Comeng900
# Prepared for post-launch calibration
# Generates a known fixed pattern
# Based on FM TV sequence 64
# 30/08/06	mcrw
#
# This sequence generates a zig-zag digital test pattern.
# CSG-ID 7 must be used.
# No internal pixels are discarded.
# No h/w windowing.
# This sequence must not be aborted. If it is then the CAM
# must be reset.

$sequence_number = 64;

sequence_id(0x0900)
sequence_repeats(1)

# Ensure the CAM analogue electronics are set explicitly
eis_cam_setup_ae(0x99, 0x99, 0x77, 0x4F, 0x0F, 0, 0, 0)

# Set sci_ops control
xrt_flare_trigger = disable
eis_aec           = disable
eis_event_trigger = disable
eis_flare_trigger = disable

eis_sci_op(xrt_flare_trigger, eis_aec, eis_event_trigger, eis_flare_trigger)

# Run raster parameters
id		= 0x0900
mip             = 0
loop_cntr       = 1
data_comp       = 0
ocb_x           = 1
ocb_y           = 1
flush_seq_id    = 2
num_flush       = 5
exp_per_ras_pos = 1
asrc_ctl        = 0
ro_node         = 0xF
ras_repeats     = 1
asrc_skip       = 0
ro_seq_id       = 7
mirror_step     = 0
line_list       = 34

eis_run_raster(id, mip, loop_cntr, data_comp, ocb_x, ocb_y, flush_seq_id, num_flush, exp_per_ras_pos, asrc_ctl, ro_node, ras_repeats, asrc_skip, ro_seq_id, mirror_step, line_list)

here:

# 0 second exposure in units of 10ms
exp_time_10ms = 0 

# Start exposure
eis_start_exp(exp_time_10ms)

eis_set_seq_loop("here")

# Put CAM analogue electronics back to normal (disable test pattern)
eis_cam_setup_ae(0x99, 0x99, 0x77, 0x2F, 0x0F, 0, 0, 0)

eis_stop_seq(64)