$sequence_number = 21;

#This sequence is used for the CAM noise measurements.

#Configure the CAM to clock the CCD data towards the left port
#but, enable the right port read-out  

sequence_id(0xface)
sequence_repeats(1)

#0x0A LEFT RO enable, but set to RIGHT enable
eis_cam_setup_ae(0x99,0x99,0x77,0x2f,0x5,0,0,0)

# Program CAM Y-start and Y-height
eis_cam_prog_csg_win(0x03,0x0,0x0c,0x80)
eis_cam_prog_csg_win(0x83,0x0,0x0c,0xc7)
eis_cam_prog_csg_win(0x03,0x0,0x14,0x92)
eis_cam_prog_csg_win(0x83,0x0,0x14,0x00)

# program CAM x_start and x_length
eis_cam_prog_csg_win(0x03,0x0,0x2D,0x80)
eis_cam_prog_csg_win(0x83,0x0,0x2D,0x32)
eis_cam_prog_csg_win(0x03,0x1,0x07,0x87)
eis_cam_prog_csg_win(0x83,0x1,0x07,0xFF)

# program CAM side L read-out
eis_cam_prog_csg_win(0x03,0x0,0x00,0x09)
eis_cam_prog_csg_win(0x83,0x0,0x00,0x66)
eis_cam_prog_csg_win(0x03,0x0,0x01,0x12)
eis_cam_prog_csg_win(0x83,0x0,0x01,0xB3)

eis_mhc_heater_on(0x0fff)

# sci operations flags
xrt_flare_trigger = disable
eis_aec           = disable
eis_event_trigger = disable
eis_flare_trigger = disable

eis_sci_op(xrt_flare_trigger, eis_aec, eis_event_trigger, eis_flare_trigger)

#Run raster parameters
id		= 0xBEEF
mip             = 0
loop_cntr       = 1
data_comp       = 0
ocb_x           = 1
ocb_y           = 1
flush_seq_id    = 2
num_flush       = 5
exp_per_ras_pos = 1
asrc_ctl        = 0x00
ro_node         = 0x5
ras_repeats     = 1
asrc_skip       = 0
ro_seq_id       = 3
mirror_step     = 32
line_list       = 18
#sci_op is implicitly handled by run_raster. No need to include as parameter

eis_run_raster(id, mip, loop_cntr, data_comp, ocb_x, ocb_y, flush_seq_id, num_flush, exp_per_ras_pos, asrc_ctl, ro_node, ras_repeats, asrc_skip, ro_seq_id, mirror_step, line_list)

here:

exp_time_10ms = 0

#Start exposure
eis_start_exp(exp_time_10ms)

eis_set_seq_loop("here")

eis_mhc_heater_off(0xffff)

eis_stop_seq(21)