$sequence_number = 30;

# This sequence exercise the MHC heaters

sequence_id(0xface)
sequence_repeats(1)

#Turn all MHC heaters OFF. 1 TO TURN HEATERS OFF
eis_mhc_heater_off(0xffff)

#Turn QCM heaters OFF (recommendation). Not recommended to have both
#structure heaters ON and QCM heaters
eis_mhc_qcm_htr(0)

#Set heaters duty cycle 
eis_mhc_parameter_set(0x212e,13107)
eis_mhc_parameter_set(0xc9af,19960)
eis_mhc_parameter_set(0xa930,9830)
eis_mhc_parameter_set(0x41b1,9830)
eis_mhc_parameter_set(0x81b2,6553)
eis_mhc_parameter_set(0x6933,6553)

eis_mhc_parameter_set(0xe1b4,26214)
eis_mhc_parameter_set(0x0935,6553)
eis_mhc_parameter_set(0xc936,6553)
eis_mhc_parameter_set(0x21b7,6553)
eis_mhc_parameter_set(0x21b8,7864)
eis_mhc_parameter_set(0xc939,3276)

#Set heaters cycle time to 100 seconds because slice is a 100 ms so 100 second
#will give tuning to 1/10th of 1%
#Min 10 seconds
#1000 * 100ms = 100 seconds

eis_mhc_parameter_set(0x093a,100)

#Turn all MHC heaters ON
#eis_mhc_heater_on(0x0fff)
eis_mhc_heater_on(0x0fff)

eis_stop_seq(30)